11/10/2023 0 Comments Ceramic idrive controller![]() ![]() Just wanna thank you again for the write up, I'm glad I found this thread because I've been wanting to retrofit the G11 ceramic controller for a while but didn't know they can be taken apart this easily for the swap. Are there any differences between IDrive. To each their own I suppose, I still love it every time I see it against the CF trim. I am thinking about picking up a used Ceramic IDrive controller for my 2018 (ID6 I believe). Of course the dealer was happy to offer to re-install one - retail cost! He also asided he didn't understand why I'd want to replace my original with the ceramic. Obviously, hence the comment, and why I PSAd it in this thread.Īlso why I'm waiting to install the LCI climate control unit till I get the software issue fixed, but my ceramic controller completely skipped my mind. That will cause an issue with the car istep being updated via this method. Huh, I wish someone had posted it in this threadĪll caveats will not be posted in every thread.Įssentially, any ECU that is foreign to your model or INTRODUCED after your date of production will cause an error on ISTA. Yes, that's a known issue that has been posted several times over the years. But I'm glad I didn't sell the stock controller like I was thinking to. Not a huge deal, I just need to swap the old one back on and take it back. They tried to update my software but the system wouldn't allow them to because it considered the ceramic iDrive controller "incompatible". I had my car at the dealer recently to get a computer issue fixed. ![]() PSA to folks, best to hold onto your old controller. Make sure the ribbon cable attached to the iDrive knob is channel through the slot (7) to the bottom of the assembly before putting the knob back in position. Now you are free to swap the switches and knobs between different EVO iDrive knobs.Īssemble in reverse order. Undo tab (6) from both sides to release the iDrive button panel. Remove the torx screw (3) holding the iDrive knob. Use a flat head screw driver to lift the ribbon cable holder (5) to remove one end of the ribbon cable. Undo four torx screws (4) holding the iDrive buttons panel.į. DO NOT mess with the four torx screws (marked in green X) as it will ruin the spacing between the magnets that control the movements of the iDrive knob.Į. Use a narrow plier to remove the rubber cap (2) to expose the torx screw (3) holding the iDrive knob.ĭ. Undo the five clips (1) at the bottom side to remove the bottom bracket.Ĭ. Remove the part number sticker from the bottom of the knob.ī. ![]()
0 Comments
Leave a Reply. |
AuthorWrite something about yourself. No need to be fancy, just an overview. ArchivesCategories |